Back to previous page
How to setup a Lay-Z-Spa Ice Bath
Lay-Z-Spa ice baths are available in different constructions. See below which applies to your Lay-Z-Spa ice bath.
Before setting up a Lay-Z-Spa ice bath
- Check that your surface is flat, level and clear of any objects such as stones, twigs etc
- If setting up on decking, it must be strong enough to hold the weight of the ice bath, water and user(s)
- If the outside temperature is cold, keep and setup the liner indoors at a temperature above 15°C
Lay-Z-Spa inflatable FortiFiber ice bath setup guide:
- Carefully lay out the liner and all parts
- Open the inflation valve and insert the inflation hose
- Inflate up to 7PSI, remove the hose and screw in valve cap
- Make sure the drain valve is closed
- If necessary screw in debris screens then attach black stopper caps over them
- Fill with water up to or above the minimum line
- Screw adapters on to pipes A and B
- Attach filter pump pipes A-A and B-B then secure in place
- Remove stopper caps from inside the ice bath
- Purge the filter pump by unscrewing the top for 30 seconds
- Place the top cover over the ice bath and fasten the clips
*Please note this does not include chemical treatment. Read here for advice.
Lay-Z-Spa steel frame ice bath setup guide:
- Carefully lay out the liner and all parts
- Following the guidance in the manual, insert the steel frame poles into the top of the ice bath
- Insert the corner and joining brackets
- Insert the leg poles and attach the feet
- Make sure the drain valve is closed
- Insert black stopper caps into the water outlets A and B
- Fill with water up to or above the minimum line
- Attach filter pump pipes A-A and B-B, then secure in place
- Remove stopper caps from inside the ice bath
- Attach the debris screens
- Purge the filter pump by unscrewing the top for 30 seconds
- Place the top cover over the ice bath and fasten the pullcord
*Please note this does not include chemical treatment. Read here for advice.
Need to get in touch?
